As usual, work has managed to get in the way to any real meaningful progress on the Kitfox but finally got back to the shop. Finished all the plumbing and wiring in the left wing and got it fully covered. So now the left and right wing are completely covered. I am still on the fence about stitching the fabric to the ribs. I have read where the Oratex adhesive is more than sufficient and other places where it's just a good idea. Doing a bit more research and have a call into Lars (Mr. Oratex himself) to discuss that. I also installed the trim booster brackets between the elevator pushrod and the flaps. Added in the kit hose clamps after Hysoling the bracket and safety wired the screws. This mod helps with the back pressure on the stick during landing/approach. There is a spring to be installed between the bracket and the fitting on the flap control. Right now I am leaving that off as words of wisdom from the factory suggest that it's better to wait till after the final rigging of the controls to where you want them in flight test before adding in the spring.